IPACHTE# 0,-"1Harnett County Department of Public Health 24516
Improvement Permit
A building permit cannot be issued with only n Improvement Permit
_ PROPERTY LOCATION: O E_ _ ~ Q \A J SON Rfl
ISSUED TO: VII--Ny P6rrz✓~ SUBDIVISION LOT #
NEW'R REPAIR ❑ EXP~NSION ❑
Type of Structure: 5v- 9 ( n z: Proposed Wastewater System Type: Fs SY 5 T~cr
Projected Daily Flow: 3co0 GPO
Number of bedrooms: 3 Number of Occupants: max
Basement ❑Yes
Pump Required:`gYes
Type of Water Supply:
Permit conditions:
Site Improvements required prior to Construction Authorization Issuance:
No
❑ No ❑ May be required based on final location and elevations of facilities
❑ Community 'FJ Public ❑ Well Distance from well 100 feet
Permit valid for.
X Five years
❑ No expiration
Authorized State Agent:: ~theHealth !no ~th. Date: Ir' I ~ SEE ATTACHED SITE SKETCH
The issuance of this permit bDepartment issuance of other permits. The permit holder is responsible for checking with appropriate goveming bodies in meeting
their requirements. This site is subject to revocation if the site plan, plat, or the intended use changes. The Improvement Permit shall not be affected by a change in ownership of the site. This
permit is subject to compliance with the provisions of the Caws and Rules for Sewage Treatment and Disposal and to conditions of this permit.
Construction Authorization
Required for Buildine Permit
The construction and installation requirements of Rules .1950, .1952. .1954, .1955, .1956, .1957, .1956, and .1959 are incorporated by references into this permit and shall be met Systems shall be
installed in accordance with the attached system layout.
ISSUED TO: ~ NN PROPERTY LOCATION: 7) os~ „sso o Y~o
1 SUBDIVISION LOT #
Facility Type: Svc (-l a-'' 3 J New ❑ Expansion ❑ Repair
Basement? ❑ Yes lam. No Basement Fixtures? ❑ Yes No
Type of Wastewater System" 'Fs ~ L S 7s rC_ t c\ (Initial) Wastewater Flow: 36b GPD
(See note below, if applicable
F t~>_ SY~-cC,,~ (Repair)
InsWation 8eWhympts/Condifas
4 -~ar<N C_..sE S
Septic Tank Size S eoa gallons Exact length of each trench cob feet Trench Spacing: 9 Feet on Center
Pump Tank Size 10~ gallons Trenches shall be installed on contour at a Soil Cover inches
Maximum Trench Depth of inches (Maximum soil cover shall not exceed
(Trench bottoms shall be level to +/-1/4" 36" above the trench bottom)
in all directions)
Pump Requirements: IL TDH vs. GPM G, inches below pipe
Aggregate Depth: inches above pipe
Conditions: SaE A~~~~o Orat6y S~cc~tS,`a>r\ros~ouASsoN `ONC~zEN~ NtL. Qt- S~ inches total
\V (;GES~yt1„Y \O t"1^r P.L~ZE 5YS'tC=.,n ~...~t36\(~N. Ute'ril~gll'~'~O to ~^I r~r.. ~S ~i-~C20U6H A MAU D~'C EG
applicable f l undemmnd the system type specified Lr different from the type specified on the application. l accept the fpecification_r of thif permit.
Owner/Legal Representative Signature: Date:
This Construction Authorization is subject.ta_zevocation if the cite nlan nlat nr thn intnndad - rh-- Th„ rnnttnvtinn anthnr6,t{nn x6,11 nnr M tr" f-4 _h.. rl,- . , ,ti,..,.e hi.,
of the site. This Constru ion Authorization so inpdiance with the provisions of the taws and Rules for Sewage Treatment and Disposal and to the conditions of this permit.
SEE ATTACHED SITE SKETCH
Authorized State Agent L Date: t
i ruction Authorization Expiration Date: ~d '
NTE# Q-) _ 5-,'"'0 Permit # a~+5~ (o
Harnett County Iepallilriellt of hiblic Health
Site Sketch
PROPERTY LOCATON: JaE ~oHtiso
ISSUED TO: V E-- SUBDIVISION LOT #
Authorized State Agent Date: _ O8
J o&L ~o•+v so N ~a
Guideline For Design and Installation of Fill Systems with Conventional Trenches
I. Trench and Fill Specifications
- Soil Texture Group
. 3 gp&sq. ft. - Acceptance Rate
X0 gpd
1 aba sq. ft
3 ft.
400 ft.
Icxo ft.
- Sewage Flow
- Trench Bottom
- Trench Width
- Total Trench Length
- Number of Trenches
- Length of each Trench
II. Site Preparation
Length of Fill
a - Width of Fill
C3L~14 sq. ft. - Total Fill Area
13 in. - Depth of Sand
QA 31% cu. yd.- Volume of Sand
(o in. - Depth of Topsoil
D CQ) 1 cu. yd. - Volume of Topsoil
1. Place flags at the 4 corners of the area to be filled designated on the improvement permit.
Failure to place fill in the permitted area may result in the fill having to be moved or the
permit revoked.
2. Do not work when the site is wet. Working on soil when wet can destroy soil structure
making the site unsuitable for a Construction Authorization.
3. Remove all above ground vegetation and root mat from area to be filled without removing
topsoil. Removal of soil can result in revocation of the permit.
4. Disk the area to be filled to a depth of 6 inches to break up root mat.
III. Placement Of Fill
1. Add 3 to 4 inches of approved sand fill to area and disk again to thoroughly mix the original
soil and the fill. Approved sand fill is a sand or loamy sand.
2. Add more sand fill to achieve a uniform height of SD (see diagram) in the middle of the fill
area.
3. The fill shall be tapered from the top edge of the fill to the ground surface 2 feet from the
boundary of the fill area. The top edge of fill is located 5 feet from the proposed trenches.
4. Six (6) inches of finer textured fill shall be placed over the sand fill and extend to the
boundary of the fill area Finer texture is necessary to establish a vegetative cover which will
prevent erosion of the fill. Fill used for cover shall be a sandy loam, loam, silt loam or sand
clay loam texture. See CD dimension of diagram. Side slope shall be 1 to 4 except for site
with Soil Texture Group 1 which can have a side slope of 1 to 3.
5. Contact Health Department for inspection of fill before constructing trenches. A
Construction Authorization must be obtained before proceeding.
N. Trench Construction
1. The outside edge of any trench shall be 5 feet from the top of the side slope of the fill.
2. This system is designed with `1 trenches which are LOO ft. long and S ft, wide.
Trenches must have a spacing of 9 ft. on centers.
3. Trench bottoms shall be no deeper than 18 inches below finished grade of the fill.
4. Trench bottoms shall be constructed level.
5. Distribution boxes shall be located 5 feet from the top edge of the fill.
6. Call the Health Department for inspection after the trenches are finished.
V. Landscaping
1. The fill must be shaped to shed surface water and shall be stabilized with grass or other
suitable cover to prevent erosion.
2. Vegetation must be maintained after established. Grass must be mowed.
3. Additional fill beyond what has already been specified may be necessary to cover and
landscape around the septic tank.
4. Call the Health Department for inspection after landscaping is complete. The Operation
Permit allowing use of the system is issued at this time:
DIMENSIONS OF FILL SYSTEM
WT = 40 ft
1 I ,
1 J
i J
l J
LT==, ft I 1
r J
I 1
J
r LB = FT
r J
1 f
1 Co = in 1
i J
SO = 13 in
we = 5 a, ft SS= 6 ft
DEFINITIONS
WT - width of top SS - side slope
LT - length of top SD - sand depth
WB - width of bottom CO - cover depth
LB - length of bottom
Calculation of Fill Volume
Total volume of fill (TVF)
TVF = [ (LT + LB) /2 X (WT + WB) /2 ] X TFD
• _ [ o FT. + 1 aa, FT. ) /2 X (.fib FT. + 5'a, FT. ) /2 ] X LIFT.
4G 4(r,
= S5 A CU. FT.
(DIVIDE BY 27 CU. FT. TO OBTAIN CU. YDS.)
- 34 CU. YDS.
Total volume of sand (TVS)
TVS=[(LT+LB -4)/2X(WT+WB-4)/2]XSD
L~C FT. + laa, FT. - 4) /2 X (~10 FT. + 5), FT. - 4) /2] X 1. t FT.
1 ~4 yA
= 5' JS CU. FT.
(DIVIDE BY 27 CU. FT. TO OBTAIN CU. YDS.)
- ao 4 CU. YDS.
Total volume of cover (TVC)
TVC = TVF - TVS
= 316 CU. YD. - -'Zq CU. YD.
- 112. CU. YD.
Key to abreviations:
LT = length of top
LB = length of bottom
WT = width of top
WB = width of bottom
TFD = total fill depth
=SD+CD
SD = sand depth
CD = cover depth